LevelOne GTL-2691 - Manual (Page 1193)

C HAPTER 42 | Multicast Filtering Commands
IGMP Snooping
– 1193 –
D EFAULT S ETTING
400 seconds
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ When a new upstream interface (that is, uplink port) starts up, the
switch sends unsolicited reports for all currently learned multicast
channels out through the new upstream interface.
◆ This command only applies when proxy reporting is enabled (see
page 1188 ).
E XAMPLE
Console(config)#ip igmp snooping unsolicited-report-interval 5
Console(config)#
ip igmp snooping
version
This command configures the IGMP snooping version. Use the no form to
restore the default.
S YNTAX
ip igmp snooping [vlan vlan-id] version {1 | 2 | 3}
no ip igmp snooping version
vlan-id - VLAN ID (Range: 1-4093)
1 - IGMP Version 1
2 - IGMP Version 2
3 - IGMP Version 3
D EFAULT S ETTING
Global: IGMP Version 2
VLAN: Not configured, based on global setting
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ This command configures the IGMP report/query version used by IGMP
snooping. Versions 1 - 3 are all supported, and versions 2 and 3 are
backward compatible, so the switch can operate with other devices,
regardless of the snooping version employed.
◆ If the IGMP snooping version is configured on a VLAN, this setting takes
precedence over the global configuration.