LevelOne GTL-2691 - Manual (Page 1091)

C HAPTER 38 | ERPS Commands
– 1091 –
erps This command enables ERPS on the switch. Use the no form to disable this
feature.
S YNTAX
[no] erps
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
ERPS must be enabled globally on the switch before it can enabled on an
ERPS ring using the enable command.
E XAMPLE
Console(config)#erps
Console(config)#
R ELATED C OMMANDS
enable (1093)
erps domain This command creates an ERPS ring and enters ERPS configuration mode
for the specified domain. Use the no form to delete a ring.
S YNTAX
[no] erps domain name
name - Name of a specific ERPS ring. (Range: 1-12 characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#erps domain r&d
Console(config-erps)#
C OMMAND U SAGE
Service Instances within each ring are based on a unique maintenance
association for the specific users, distinguished by the ring name,
maintenance level, maintenance association’s name, and assigned VLAN.
Up to 6 ERPS rings can be configured on the switch.