LevelOne GTL-2691 - Manual (Page 860)

C HAPTER 27 | Flow Sampling Commands
– 860 –
sflow timeout This command configures the length of time samples are sent to the
Collector before resetting all sFlow port parameters. Use the no form to
restore the default time out.
S YNTAX
sflow timeout seconds
no sflow timeout
seconds - The length of time the sFlow process continuously sends
samples to the Collector before resetting all sFlow port parameters.
(Range: 0-10000000 seconds, where 0 indicates no time out)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet)
C OMMAND U SAGE
The sFlow parameters affected by this command include the sampling
interval, the receiver’s name, address and UDP port, the time out,
maximum header size, and maximum datagram size.
E XAMPLE
This example sets the time out to 1000 seconds.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow timeout 10000
Console(config-if)#
show sflow This command shows the global and interface settings for the sFlow
process.
S YNTAX
show sflow interface [interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)