LevelOne GTL-2691 - Manual (Page 1160)

C HAPTER 40 | Class of Service Commands
Priority Commands (Layer 2)
– 1160 –
E XAMPLE
The following example shows how to set a default priority on port 3 to 5:
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#
R ELATED C OMMANDS
show interfaces switchport (1011)
show queue cos-
map
This command shows the class of service priority map.
S YNTAX
show queue cos-map [interface]
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
None
C OMMAND M ODE
Privileged Exec
E XAMPLE
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 2 0 1 3 4 5 6 7
Console#
show queue mode This command shows the current queue mode.
S YNTAX
show queue mode interface
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)