LevelOne GTL-2691 - Manual (Page 777)

C HAPTER 24 | System Management Commands
Fan Control
– 777 –
between the two end nodes must be able to accept the extended frame
size. And for half-duplex connections, all devices in the collision domain
would need to support jumbo frames.
◆ This command globally enables support for jumbo frames on all Gigabit
and 10 Gigabit ports and trunks. To set the MTU for a specific interface,
enable jumbo frames and use the switchport mtu command to specify
the required size of the MTU.
◆ The current setting for jumbo frames can be displayed with the show
system command.
E XAMPLE
Console(config)#jumbo frame
Console(config)#
R ELATED C OMMANDS
switchport mtu (1005)
show system (773)
show ipv6 mtu (1418)
F AN C ONTROL
This section describes the command used to force fan speed.
fan-speed force-full This command sets all fans to full speed. Use the no form to reset the fans
to normal operating speed.
S YNTAX
[no] fan-speed force-full
D EFAULT S ETTING
Normal speed
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#fan-speed force-full
Console(config)#
Table 48: Fan Control Commands
Command Function Mode
fan-speed force-full Forces fans to full speed GC
show system Shows if full fan speed is enabled NE, PE