LevelOne GTL-2691 - Manual (Page 915)

C HAPTER 28 | Authentication Commands
PPPoE Intermediate Agent
– 915 –
pppoe intermediate-
agent port-enable
This command enables the PPPoE IA on an interface. Use the no form to
disable this feature.
S YNTAX
[no] pppoe intermediate-agent port-enable
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
PPPoE IA must also be enabled globally on the switch for this command to
take effect.
E XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
pppoe intermediate-
agent port-format-
type
This command sets the circuit-id or remote-id for an interface. Use the no
form to restore the default settings.
S YNTAX
pppoe intermediate-agent port-format-type {circuit-id |
remote-id} id-string
circuit-id - String identifying the circuit identifier (or interface) on
this switch to which the user is connected. (Range: 1-10 ASCII
characters)
remote-id - String identifying the remote identifier (or interface)
on this switch to which the user is connected. (Range: 1-63 ASCII
characters)
D EFAULT S ETTING
circuit-id: unit/port:vlan-id or 0/trunk-id:vlan-id
remote-id: port MAC address
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
◆ The PPPoE server extracts the Line-ID tag from PPPoE discovery stage
messages, and uses the Circuit-ID field of that tag as a NAS-Port-ID
attribute in AAA access and accounting requests.