LevelOne GTL-2691 - Manual (Page 796)

C HAPTER 24 | System Management Commands
Line
– 796 –
stopbits This command sets the number of the stop bits transmitted per byte. Use
the no form to restore the default setting.
S YNTAX
stopbits {1 | 2}
no stopbits
1 - One stop bit
2 - Two stop bits
D EFAULT S ETTING
1 stop bit
C OMMAND M ODE
Line Configuration
E XAMPLE
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
timeout login
response
This command sets the interval that the system waits for a user to log into
the CLI. Use the no form to restore the default setting.
S YNTAX
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 10 - 300 seconds; 0: disabled)
D EFAULT S ETTING
300 seconds
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
◆ If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
◆ This command applies to both the local console and Telnet connections.
◆ The timeout for Telnet cannot be disabled.
◆ Using the command without specifying a timeout restores the default
setting.