LevelOne GTL-2691 - Manual (Page 914)

C HAPTER 28 | Authentication Commands
PPPoE Intermediate Agent
– 914 –
port-ID attribute in PPP authentication and AAA accounting requests to
a RADIUS server.
◆ PPPoE IA must be enabled globally by this command before this feature
can be enabled on an interface using the pppoe intermediate-agent
port-enable command.
E XAMPLE
Console(config)#pppoe intermediate-agent
Console(config)#
pppoe intermediate-
agent format-type
This command sets the access node identifier and generic error message
for the switch. Use the no form to restore the default settings.
S YNTAX
pppoe intermediate-agent format-type {access-node-identifier
id-string | generic-error-message error-message}
no pppoe intermediate-agent format-type {access-node-
identifier | generic-error-message}
id-string - String identifying this switch as an PPPoE IA to the PPPoE
server. (Range: 1-48 ASCII characters)
error-message - An error message notifying the sender that the
PPPoE Discovery packet was too large.
D EFAULT S ETTING
◆ Access Node Identifier: IP address of first IPv4 interface on the switch.
◆ Generic Error Message: PPPoE Discover packet too large to process. Try
reducing the number of tags added.
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ The switch uses the access-node-identifier to generate the circuit-id for
PPPoE discovery stage packets sent to the BRAS, but does not modify
the source or destination MAC address of these PPPoE discovery
packets.
◆ These messages are forwarded to all trusted ports designated by the
pppoe intermediate-agent trust command.
E XAMPLE
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#