Spanning-tree loopback-detection release-mode, Spanning-tree loopback, Detection release-mode – LevelOne GTL-2691 User Manual

Page 1078

Advertising
background image

C

HAPTER

37

| Spanning Tree Commands

– 1078 –

command, the selected interface will be automatically enabled when

the shutdown interval has expired.

◆

If an interface is shut down by this command, and the release mode is

set to “manual,” the interface can be re-enabled using the

spanning-

tree loopback-detection release

command.

E

XAMPLE

Console(config)#interface ethernet 1/5

Console(config-if)#spanning-tree loopback-detection action shutdown 600

spanning-tree

loopback-detection

release-mode

This command configures the release mode for a port that was placed in

the discarding state because a loopback BPDU was received. Use the no

form to restore the default.

S

YNTAX

spanning-tree loopback-detection release-mode

{auto | manual}

no spanning-tree loopback-detection release-mode

auto - Allows a port to automatically be released from the

discarding state when the loopback state ends.
manual - The port can only be released from the discarding state

manually.

D

EFAULT

S

ETTING

auto

C

OMMAND

M

ODE

Interface Configuration (Ethernet, Port Channel)

C

OMMAND

U

SAGE

◆

If the port is configured for automatic loopback release, then the port

will only be returned to the forwarding state if one of the following

conditions is satisfied:

■

The port receives any other BPDU except for it’s own, or;

■

The port’s link status changes to link down and then link up again,

or;

■

The port ceases to receive it’s own BPDUs in a forward delay

interval.

◆

If Port Loopback Detection is not enabled and a port receives it’s own

BPDU, then the port will drop the loopback BPDU according to IEEE

Standard 802.1W-2001 9.3.4 (Note 1).

◆

Port Loopback Detection will not be active if Spanning Tree is disabled

on the switch.

Advertising