LevelOne GTL-2691 - Manual (Page 1229)

C HAPTER 42 | Multicast Filtering Commands
MVR for IPv4
– 1229 –
E XAMPLE
The following an MVR group address profile to domain 1:
Console(config)#mvr domain 1 associated-profile rd
Console(config)#
R ELATED C OMMANDS
mvr profile (1229)
mvr domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
S YNTAX
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages.
If MVR must be configured for an IGMP version 1 host, the multicast
groups must be statically assigned using the mvr vlan group command.
E XAMPLE
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr profile This command maps a range of MVR group addresses to a profile. Use the
no form of this command to remove the profile.
S YNTAX
mvr profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv4 address for an MVR multicast
group. (Range: 224.0.1.0 - 239.255.255.255)
end-ip-address - Ending IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)