Show ipv6 access- group, Mac acls, Access-list mac – LevelOne GTL-2691 User Manual
Page 986: Show ipv6 access-group, Table 96: mac acl commands, Mac acl
C
HAPTER
30
| Access Control Lists
MAC ACLs
– 986 –
show ipv6 access-
group
This command shows the ports assigned to IPv6 ACLs.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#show ipv6 access-group
Interface ethernet 1/2
IPv6 access-list david in
Console#
R
ELATED
C
OMMANDS
MAC ACL
S
The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. To configure MAC ACLs, first
create an access list containing the required permit or deny rules, and then
bind the access list to one or more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no
spaces or other special characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
Table 96: MAC ACL Commands
Command
Function
Mode
Creates a MAC ACL and enters configuration mode
GC
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
MAC-ACL
Binds a MAC ACL to a port
IC
Shows port assignments for MAC ACLs
PE
Displays the rules for configured MAC ACLs
PE