LevelOne GTL-2691 - Manual (Page 626)

C HAPTER 18 | General IP Routing
Configuring IP Routing Interfaces
– 626 –
W EB I NTERFACE
To ping another device on the network:
1. Click IP, General, Ping.
2. Specify the target device and ping parameters.
3. Click Apply.
Figure 380: Pinging a Network Device
U SING THE T RACE
R OUTE F UNCTION
Use the IP > General > Trace Route page to show the route packets take to
the specified destination.
CLI R EFERENCES
◆ "traceroute" on page 1396
P ARAMETERS
These parameters are displayed:
◆ Destination IP Address – IPv4 address of the host.
C OMMAND U SAGE
◆ Use the trace route function to determine the path taken to reach a
specified destination.
◆ A trace terminates when the destination responds, when the maximum
timeout (TTL) is exceeded, or the maximum number of hops is
exceeded.
◆ The trace route function first sends probe datagrams with the TTL value
set at one. This causes the first router to discard the datagram and
return an error message. The trace function then sends several probe
messages at each subsequent TTL level and displays the round-trip
time for each message. Not all devices respond correctly to probes by