LevelOne GTL-2691 - Manual (Page 369)

C HAPTER 13 | Security Measures
Access Control Lists
– 369 –
Figure 190: Configuring a ARP ACL
B INDING A P ORT TO AN
A CCESS C ONTROL
L IST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI R EFERENCES
◆ "ip access-group" on page 978
◆ "ipv6 access-group" on page 985
◆ "show ip access-group" on page 979
◆ "show ipv6 access-group" on page 986
◆ "mac access-group" on page 989
◆ "show mac access-group" on page 990
◆ "Time Range" on page 817
C OMMAND U SAGE
◆ This switch supports ACLs for ingress filtering only.
◆ You only bind one ACL to any port for ingress filtering.
P ARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.