LevelOne GTL-2691 - Manual (Page 1481)

C HAPTER 49 | IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1481 –
E XAMPLE
Console#clear ip ospf process
Console#
Route Metrics and Summaries
area default-cost This command specifies a cost for the default summary route sent into a
stub or NSSA from an Area Border Router (ABR). Use the no form to
remove the assigned default cost.
S YNTAX
area area-id default-cost cost
no area area-id default-cost
area-id - Identifies the stub or NSSA. (The area ID can be in the
form of an IPv4 address or as a four octet unsigned integer ranging
from 0-4294967295.)
cost - Cost for the default summary route sent to a stub or NSSA.
(Range: 0-16777215)
C OMMAND M ODE
Router Configuration
D EFAULT S ETTING
Default cost: 1
C OMMAND U SAGE
◆ If the default cost is set to “0,” the router will not advertise a default
route into the attached stub or NSSA.
E XAMPLE
Console(config-router)#area 10.3.9.0 default-cost 10
Console(config-router)#
R ELATED C OMMANDS
area stub (1489)
area nssa (1487)