LevelOne GTL-2691 - Manual (Page 509)

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 509 –
◆ Alarm Time – The time a defect must exist before a fault alarm is
issued
10 .
◆ Reset Time – The time after a fault alarm has been issued, and no
defect exists, before another fault alarm can be issued
10 .
W EB I NTERFACE
To show configuration settings for the fault notification generator:
1. Click Administration, CFM.
2.
Select Show Information from the Step list.
3.
Select Show Fault Notification Generator from the Action list.
Figure 287: Showing Settings for the Fault Notification Generator
D ISPLAYING
C ONTINUITY C HECK
E RRORS
Use the Administration > CFM > Show Information (Show Continuity Check
Error) page to display the CFM continuity check errors logged on this
device.
CLI R EFERENCES
◆ "show ethernet cfm errors" on page 1334
◆ "clear ethernet cfm errors" on page 1333
P ARAMETERS
These parameters are displayed:
◆ Level – Maintenance level associated with this entry.
◆ Primary VLAN – VLAN in which this error occurred.
◆ MEP ID – Identifier of remote MEP.
◆ Remote MAC – MAC address of remote MEP.
◆ Reason – Error types include:
■
LEAK – MA x is associated with a specific VID list 11 , one or more of
the VIDs in this MA can pass through the bridge port, no MEP is
configured facing outward (down) on any bridge port for this MA,
10. See "Configuring CFM Maintenance Domains" on page 481 .
11. This definition is based on the IEEE 802.1ag standard. Current software for this switch
only supports a single VLAN per MA. However, since it may interact with other devices
which support multiple VLAN assignments per MA, this error message may be reported.