Displaying rip interface settings, Figure 417: showing rip network interface settings – LevelOne GTL-2691 User Manual
Page 666
C
HAPTER
20
| Unicast Routing
Configuring the Routing Information Protocol
– 666 –
Figure 416: Configuring a Network Interface for RIP
To show the network interface settings configured for RIP:
1.
Click Routing Protocol, RIP, Interface.
2.
Select Show from the Action list.
Figure 417: Showing RIP Network Interface Settings
D
ISPLAYING
RIP
I
NTERFACE
S
ETTINGS
Use the Routing Protocol > RIP > Statistics (Show Interface Information)
page to display information about RIP interface configuration settings.
CLI R
EFERENCES
◆
P
ARAMETERS
These parameters are displayed:
◆
Interface – Source IP address of RIP router interface.
◆
Auth Type – The type of authentication used for exchanging RIPv2
protocol messages.
◆
Send Version – The RIP version to sent on this interface.
◆
Receive Version – The RIP version accepted on this interface.
◆
Rcv Bad Packets – Number of bad RIP packets received.