LevelOne GTL-2691 - Manual (Page 605)

C HAPTER 17 | IP Services
Dynamic Host Configuration Protocol
– 605 –
E NABLING THE S ERVER
Use the IP Service > DHCP > Server (Configure Global) page to enable the
DHCP Server.
CLI R EFERENCES
◆ "service dhcp" on page 1370
P ARAMETERS
These parameters are displayed:
◆ DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
W EB I NTERFACE
To enable the DHCP server:
1.
Click IP Service, DHCP, Server.
2. Select Configure Global from the Step list.
3.
Mark the Enabled box.
4.
Click Apply.
Figure 364: Enabling the DHCP Server
S ETTING E XCLUDED A DDRESSES
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add)
page to specify the IP addresses that should not be assigned to clients.
CLI R EFERENCES
◆ "ip dhcp excluded-address" on page 1369
P ARAMETERS
These parameters are displayed:
◆ Start IP Address – Specifies a single IP address or the first address in
a range that the DHCP server should not assign to DHCP clients.