LevelOne GTL-2691 - Manual (Page 1266)

C HAPTER 42 | Multicast Filtering Commands
IGMP (Layer 3)
– 1266 –
request to join the multicast group will also fail if the next node up the
reverse path tree has enabled the PIM-SSM protocol.
◆ If a static group is configured for an any-source multicast (*,G), a
source address cannot subsequently be defined for this group without
first deleting the entry.
◆ If a static group is configured for one or more source-specific multicasts
(S,G), an any-source multicast (*,G) cannot subsequently be defined
for this group without first deleting all of the associated (S,G) entries.
◆ Using the no form of this command to delete a static group without
specifying the source address will delete all any-source and source-
specific multicast entries for the specified group.
◆ The switch supports a maximum of 16 static group entries.
E XAMPLE
The following example assigns VLAN 1 as a static member of the specified
multicast group.
Console(config)#interface vlan 1
Console(config-if)#ip igmp static-group 225.1.1.1
ip igmp version This command configures the IGMP version used on an interface. Use the
no form of this command to restore the default.
S YNTAX
ip igmp version {1 | 2 | 3}
no ip igmp version
1 - IGMP Version 1
2 - IGMP Version 2
3 - IGMP Version 3
D EFAULT S ETTING
IGMP Version 2
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ All routers on the subnet must support the same version. However, the
multicast hosts on the subnet may support any of the IGMP versions
1 - 3.
◆ If the switch receives an IGMP Version 1 Membership Report, it sets a
timer to note that there are Version 1 hosts which are members of the
group for which it heard the report.