LevelOne GTL-2691 - Manual (Page 156)

C HAPTER 4 | Basic Management Tasks
Displaying Memory Utilization
– 156 –
D ISPLAYING M EMORY U TILIZATION
Use the System > Memory Status page to display memory utilization
parameters.
CLI R EFERENCES
◆ "show memory" on page 770
P ARAMETERS
The following parameters are displayed:
◆ Free Size – The amount of memory currently free for use.
◆ Used Size – The amount of memory allocated to active processes.
◆ Total – The total amount of system memory.
W EB I NTERFACE
To display memory utilization:
1.
Click System, then Memory Status.
Figure 24: Displaying Memory Utilization
R ENUMBERING THE S TACK
If the units are no longer numbered sequentially after several topology
changes or failures, use the System > Renumbering page to reset the unit
numbers. Just remember to save the new configuration settings to a
startup configuration file prior to powering off the stack Master.
CLI R EFERENCES
◆ "switch all renumber" on page 768
C OMMAND U SAGE
◆ The startup configuration file maps configuration settings to each
switch in the stack based on the unit identification number. You should
therefore remember to save the current configuration after
renumbering the stack.
◆ For a line topology, the stack is numbered from top to bottom, with the
first unit in the stack designated at unit 1. For a ring topology, the