LevelOne GTL-2691 - Manual (Page 329)

C HAPTER 13 | Security Measures
Web Authentication
– 329 –
C ONFIGURING
I NTERFACE S ETTINGS
FOR W EB
A UTHENTICATION
Use the Security > Web Authentication (Configure Interface) page to
enable web authentication on a port, and display information for any
connected hosts.
CLI R EFERENCES
◆ "Web Authentication" on page 940
P ARAMETERS
These parameters are displayed:
◆ Port – Indicates the port being configured.
◆ Status – Configures the web authentication status for the port.
◆ Host IP Address – Indicates the IP address of each connected host.
◆ Remaining Session Time – Indicates the remaining time until the
current authorization session for the host expires.
◆ Apply – Enables web authentication if the Status box is checked. Also
ends all authenticated web sessions for selected host IP addresses in
the Authenticated Host List, and forces the users to re-authenticate.
◆ Revert – Restores the previous configuration settings.
◆ Re-authenticate – Ends all authenticated web sessions for selected
host IP addresses in the Authenticated Host List, and forces the users
to re-authenticate.
W EB I NTERFACE
To enable web authentication for a port:
1.
Click Security, Web Authentication.
2. Select Configure Interface from the Step list.
3. Set the status box to enabled for any port that requires web
authentication.
4. Mark the check box for any host addresses that need to be re-
authenticated.
5.
Click Apply.