LevelOne GTL-2691 - Manual (Page 773)

C HAPTER 24 | System Management Commands
System Status
– 773 –
◆ This command displays settings for key command modes. Each mode
group is separated by “!” symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
■
MAC address for each switch in the stack
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for VLANs
■
Layer 4 precedence settings
■
Routing protocol configuration settings
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
E XAMPLE
Refer to the example for the running configuration file.
R ELATED C OMMANDS
show running-config (771)
show system This command displays system information.
D EFAULT S ETTING
None
C OMMAND M ODE
Normal Exec, Privileged Exec
C OMMAND U SAGE
◆ For a description of the items shown by this command, refer to
"Displaying System Information" on page 129 .
◆ There are three fans in the switch. Fan 1 and 2 are inside the unit and
provide cooling for the power supply. Fan 3 is located on the right side
of the unit, and forces air out.
◆ There are two thermal detectors in both models The first detector is
near the air flow intake vents. The second detector is near the switch
ASIC and CPU.
◆ No information will be displayed under POST Result, unless there is a
problem with the unit. If any POST test indicates “FAIL,” contact your
distributor for assistance.