Timers basic – LevelOne GTL-2691 User Manual

Page 1465

Advertising
background image

C

HAPTER

49

| IP Routing Commands

Routing Information Protocol (RIP)

– 1465 –

timers basic

This command configures the RIP update timer, timeout timer, and

garbage- collection timer. Use the no form to restore the defaults.

S

YNTAX

timers basic update timeout garbage
no timers basic

update – Sets the update timer to the specified value.

(Range: 5-2147483647 seconds)
timeout – Sets the timeout timer to the specified value.

(Range: 90-360 seconds)
garbage – Sets the garbage collection timer to the specified value.

(Range: 60-240 seconds)

D

EFAULT

S

ETTING

Update: 30 seconds

Timeout: 180 seconds

Garbage collection: 120 seconds

C

OMMAND

M

ODE

Router Configuration

C

OMMAND

U

SAGE

◆

The update timer sets the rate at which updates are sent. This is the

fundamental timer used to control all basic RIP processes.

◆

The timeout timer is the time after which there have been no update

messages that a route is declared dead. The route is marked

inaccessible (i.e., the metric set to infinite) and advertised as

unreachable. However, packets are still forwarded on this route.

◆

After the timeout interval expires, the router waits for an interval

specified by the garbage-collection timer before removing this entry

from the routing table. This timer allows neighbors to become aware of

an invalid route prior to it being purged by this device.

◆

Setting the update timer to a short interval can cause the router to

spend an excessive amount of time processing updates.

◆

These timers must be set to the same values for all routers in the

network.

E

XAMPLE

This example sets the update timer to 40 seconds. The timeout timer is

subsequently set to 240 seconds, and the garbage-collection timer to 160

seconds.

Console(config-router)#timers basic 15

Console(config-router)#

Advertising