LevelOne GTL-2691 - Manual (Page 754)

C HAPTER 22 | Using the Command Line Interface
Entering Commands
– 754 –
◆ Line Configuration - These commands modify the console port and
Telnet configuration, and include command such as parity and
databits.
◆ Multiple Spanning Tree Configuration - These commands configure
settings for the selected multiple spanning tree instance.
◆ Policy Map Configuration - Creates a DiffServ policy map for multiple
interfaces.
◆ Router Configuration - These commands configure global settings for
unicast and multicast routing protocols.
◆ Time Range - Sets a time range for use by other functions, such as
Access Control Lists.
◆ VLAN Configuration - Includes the command to create VLAN groups.
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
Table 40: Configuration Command Modes
Mode Command Prompt Page
Access
Control List
access-list arp
access-list ip standard
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl) 991
974
974
986
981
982
CFM ethernet cfm domain Console(config-ether-cfm) 1315
Class Map class-map Console(config-cmap) 1170
DHCP ip dhcp pool Console(config-dhcp) 1370
ERPS erps domain Console(config-erps) 1091
Interface interface {ethernet port |
port-channel id| vlan id}
Console(config-if) 998
Line line {console | vty} Console(config-line) 789
MSTP spanning-tree mst-configuration Console(config-mstp) 1067
Policy Map policy-map Console(config-pmap) 1173