LevelOne GTL-2691 - Manual (Page 757)

C HAPTER 22 | Using the Command Line Interface
CLI Command Groups
– 757 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CM (Class Map Configuration)
DC (DHCP Server Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table, or
sets the aging time
1055
Spanning Tree Configures Spanning Tree settings for the switch 1061
ERPS Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
1089
VLANs Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
1107
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for TCP/UDP traffic
types, IP precedence, and DSCP
1155
Quality of Service Configures Differentiated Services 1169
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration, and
IPv6 MLD snooping
1185
Link Layer Discovery
Protocol Configures LLDP settings to enable information discovery
about neighbor devices
1285
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
1309
Domain Name Service Configures DNS services. 1351
Dynamic Host
Configuration Protocol
Configures DHCP client, relay and server functions 1361
Router Redundancy Configures router redundancy to create primary and
backup routers
1381
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters and static entries
1391
IP Routing Configures static and dynamic unicast routing 1447
Multicast Routing Configures multicast routing protocols PIM-DM and
PIM-SM
1545
Table 42: Command Group Index (Continued)
Command Group Description Page