LevelOne GTL-2691 - Manual (Page 667)

C HAPTER 20 | Unicast Routing
Configuring the Routing Information Protocol
– 667 –
◆ Rcv Bad Routes – Number of bad routes received.
◆ Send Updates – Number of route changes.
W EB I NTERFACE
To display RIP interface configuration settings:
1.
Click Routing Protocol, RIP, Statistics.
2. Select Show Interface Information from the Action list.
Figure 418: Showing RIP Interface Settings
D ISPLAYING P EER
R OUTER I NFORMATION
Use the Routing Protocol > RIP > Statistics (Show Peer Information) page
to display information on neighboring RIP routers.
CLI R EFERENCES
◆ "show ip protocols rip" on page 1473
P ARAMETERS
These parameters are displayed:
◆ Peer Address – IP address of a neighboring RIP router.
◆ Update Time – Last time a route update was received from this peer.
◆ Version – Shows whether RIPv1 or RIPv2 packets were received from
this peer.
◆ Rcv Bad Packets – Number of bad RIP packets received from this
peer.
◆ Rcv Bad Routes – Number of bad routes received from this peer.
W EB I NTERFACE
To display information on neighboring RIP routers:
1. Click Routing Protocol, RIP, Statistics.
2. Select Show Peer Information from the Action list.