Spanning-tree port- bpdu-flooding, Spanning-tree port-bpdu-flooding, Spanning-tree port-bpdu – LevelOne GTL-2691 User Manual

Page 1081: Flooding

Advertising
background image

C

HAPTER

37

| Spanning Tree Commands

– 1081 –

C

OMMAND

U

SAGE

◆

This command defines the priority for the use of an interface in the

multiple spanning-tree. If the path cost for all interfaces on a switch are

the same, the interface with the highest priority (that is, lowest value)

will be configured as an active link in the spanning tree.

◆

Where more than one interface is assigned the highest priority, the

interface with lowest numeric identifier will be enabled.

E

XAMPLE

Console(config)#interface Ethernet 1/5

Console(config-if)#spanning-tree mst 1 port-priority 0

Console(config-if)#

R

ELATED

C

OMMANDS

spanning-tree mst cost (1079)

spanning-tree port-

bpdu-flooding

This command floods BPDUs to other ports when spanning tree is disabled

globally or disabled on a specific port. Use the no form to restore the

default setting.

S

YNTAX

[no] spanning-tree port-bpdu-flooding

D

EFAULT

S

ETTING

Enabled

C

OMMAND

M

ODE

Interface Configuration (Ethernet, Port Channel)

C

OMMAND

U

SAGE

◆

When enabled, BPDUs are flooded to all other ports on the switch or to

all other ports within the receiving port’s native VLAN as specified by

the

spanning-tree system-bpdu-flooding

command.

◆

The

spanning-tree system-bpdu-flooding

command has no effect if

BPDU flooding is disabled on a port by the spanning-tree port-bpdu-

flooding command.

E

XAMPLE

Console(config)#interface ethernet 1/5

Console(config-if)#spanning-tree port-bpdu-flooding

Console(config-if)#

Advertising