LevelOne GTL-2691 - Manual (Page 1397)

C HAPTER 48 | IP Interface Commands
IPv4 Interface
– 1397 –
◆ A trace terminates when the destination responds, when the maximum
timeout (TTL) is exceeded, or the maximum number of hops is
exceeded.
◆ The traceroute command first sends probe datagrams with the TTL
value set at one. This causes the first router to discard the datagram
and return an error message. The trace function then sends several
probe messages at each subsequent TTL level and displays the round-
trip time for each message. Not all devices respond correctly to probes
by returning an “ICMP port unreachable” message. If the timer goes off
before a response is returned, the trace function prints a series of
asterisks and the “Request Timed Out” message. A long sequence of
these messages, terminating only when the maximum timeout has
been reached, may indicate this problem with the target device.
◆ If the target device does not respond or other errors are detected, the
switch will indicate this by one of the following messages:
■
* - No Response
■
H - Host Unreachable
■
N - Network Unreachable
■
P - Protocol Unreachable
■
O -Other
E XAMPLE
Console#traceroute 192.168.0.1
Press "ESC" to abort.
Traceroute to 192.168.0.1, 30 hops max, timeout is 3 seconds
Hop Packet 1 Packet 2 Packet 3 IP Address
--- -------- -------- -------- ---------------
1 <10 ms <10 ms 1000 ms 192.168.0.1
Trace completed.
Console#
ping This command sends (IPv4) ICMP echo request packets to another node on
the network.
S YNTAX
ping host [count count] [size size]
host - IP address or IP alias of the host.
count - Number of packets to send. (Range: 1-16)
size - Number of bytes in a packet. (Range: 32-512)
The actual packet size will be eight bytes larger than the size
specified because the router adds header information.
D EFAULT S ETTING
count: 5
size: 32 bytes