LevelOne GTL-2691 - Manual (Page 790)

C HAPTER 24 | System Management Commands
Line
– 790 –
databits This command sets the number of data bits per character that are
interpreted and generated by the console port. Use the no form to restore
the default value.
S YNTAX
databits {7 | 8}
no databits
7 - Seven data bits per character.
8 - Eight data bits per character.
D EFAULT S ETTING
8 data bits per character
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits
per character.
E XAMPLE
To specify 7 data bits, enter this command:
Console(config-line)#databits 7
Console(config-line)#
R ELATED C OMMANDS
parity (792)
exec-timeout This command sets the interval that the system waits until user input is
detected. Use the no form to restore the default.
S YNTAX
exec-timeout [seconds]
no exec-timeout
seconds - Integer that specifies the timeout interval.
(Range: 60 - 65535 seconds)
D EFAULT S ETTING
600 seconds
C OMMAND M ODE
Line Configuration