LevelOne GTL-2691 - Manual (Page 885)

C HAPTER 28 | Authentication Commands
Web Server
– 885 –
ip http secure-port This command specifies the UDP port number used for HTTPS connection to
the switch’s web interface. Use the no form to restore the default port.
S YNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
D EFAULT S ETTING
443
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ You cannot configure the HTTP and HTTPS servers to use the same
port.
◆ If you change the HTTPS port number, clients attempting to connect to
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
E XAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
R ELATED C OMMANDS
ip http secure-server (885)
show system (773)
ip http secure-
server
This command enables the secure hypertext transfer protocol (HTTPS) over
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
connection) to the switch’s web interface. Use the no form to disable this
function.
S YNTAX
[no] ip http secure-server
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Global Configuration