LevelOne GTL-2691 - Manual (Page 1321)

C HAPTER 44 | CFM Commands
Defining CFM Structures
– 1321 –
ethernet cfm port-
enable
This command enables CFM processing on an interface. Use the no form to
disable CFM processing on an interface.
S YNTAX
[no] ethernet cfm port-enable
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Interface Configuration (Ethernet, Port Channel)
C OMMAND U SAGE
◆ An interface must be enabled before a MEP can be created with the
ethernet cfm mep command.
◆ If a MEP has been configured on an interface with the ethernet cfm mep
command, it must first be deleted before CFM can be disabled on that
interface.
◆ When CFM is disabled, hardware resources previously used for CFM
processing on that interface are released, and all CFM frames entering
that interface are forwarded as normal data traffic.
E XAMPLE
This example enables CFM on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm port-enable
Console(config-if)#
clear ethernet cfm
ais mpid
This command clears AIS defect information for the specified MEP.
S YNTAX
clear ethernet cfm ais mpid mpid md domain-name ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-44
alphanumeric characters)
D EFAULT S ETTING
None
C OMMAND M ODE
Privileged Exec