Lenze E94ARNE Regenerative power supply - Manual (Page 240)

9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
240
L
EDS94ARNExxxx EN 2.3 - 06/2014
Lenze setting loaded [0x00900001]
Parameter set saved [0x00900002]
Parameter set loaded [0x00900003]
Loading of Lenze setting failed [0x00900004]
Parameter set restored [0x00900005]
Saving of parameters failed [0x00900006]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Lenze setting has been loaded. - (Information only)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Parameter set has been saved. - (Information only)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Parameter set has been loaded. - (Information only)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Lenze setting of a parameter is not within the valid
limits.
Eliminate error in the application and then transfer
application to the regenerative power supply module
again.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An error has occurred while loading the selected
parameter set.
Transfer parameter set from the Engineer to the
regenerative power supply module and save it with
C00002 ="11".
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An error has occurred while saving the current
parameter set.
Use a different memory module.