Lenze E94ARNE Regenerative power supply - Manual (Page 64)

9400 regenerative power supply module | Parameter setting
Device interface
Device commands
64
L
EDS94ARNExxxx EN 2.3 - 06/2014
4.1.24 CAN module: Reset node
The C00002 = "92: CAN module: Reset node" device command serves to reinitialise the
CANopen interface of a CANopen communication module inserted in module slot MXI1 or
MXI2. This is required, for instance, after changing the data transfer rate, the node address,
or identifiers.

Tip!
Detailed information on the CANopen communication module (E94AYCCA) can be
found in the "CAN" Communication Manual.
Possible status displays for this device command
Related device commands
 CAN module: Pred.Connect.Set
( 66)
 CAN module: Identify node
( 68)
Status ( C00003 ) Meaning
6063362 Device command in process
6029312 Device command executed successfully
6029313 General fault
6068736 CAN fault
...
6068991 CAN fault