Lenze E94ARNE Regenerative power supply - Manual (Page 56)

9400 regenerative power supply module | Parameter setting
Device interface
Device commands
56
L
EDS94ARNExxxx EN 2.3 - 06/2014
4.1.16 Enable controller
The device command C00002 = "42: Enable controller" serves to re-enable an inhibited
regenerative power supply module.

Tip!
This device command can also be activated via the icon in the Toolbar.
Related device commands
 Inhibit controller
( 55)

Note!
Please note that the regenerative power supply module will only be enabled if all
sources for controller inhibit are reset!
• The sources or trip elements that are active for controller inhibit are displayed
in a bit-coded manner in C00158 .
This device command has no status display in C00003 , i.e. the display remains
unchanged showing the previous device command status.