Lenze E94ARNE Regenerative power supply - Manual (Page 81)

EDS94ARNExxxx EN 2.3 - 06/2014
L
81
9400 regenerative power supply module | Parameter setting
Device interface
Device states
4.2.2 State "Device is ready to switch on"
This is the device state of the regenerative power supply module directly after the
initialisation has been completed and a DC-bus voltage is not applied yet.
 The bus systems are running and the terminals and encoders are evaluated.
 The monitoring functions are active.
 The regenerative power supply module can be parameterised and device commands
can be executed to a limited extent.
 The application is basically executable.
4.2.3 State "Device is switched on"
This is device state of the regenerative power supply module when the DC-bus voltage is
applied and the regenerative power supply module is still inhibited by the user (controller
inhibit).
 The bus systems are running and the terminals and encoders are evaluated.
 The monitoring functions are active.
 The regenerative power supply module can be parameterised and device commands
can be executed to a limited extent.
 The application is basically executable.
LED DRIVE READY LED DRIVE ERROR Display in C00183
OFF 141: Device ready to start

Note!
The "Device is ready to switch on" state is not only entered after power-on, but
also when a "Trouble" or "Fault" is reset.
• For
C00142 = "1: Enabled", the device changes directly from the "Device is
ready to switch on" state to the "Device is switched on" state (Lenze setting).
• For C00142 = "0: Inhibited", at least one source for controller must be active
to get from the "Device is ready to switch on" state to the "Device is switched
on" state.
 Automatic restart after power-on/trouble/fault
( 84)
LED DRIVE READY LED DRIVE ERROR Display in C00183
OFF 90: Drive switched on