Lenze E94ARNE Regenerative power supply - Manual (Page 38)

9400 regenerative power supply module | Parameter setting
Device interface
Device commands
38
L
EDS94ARNExxxx EN 2.3 - 06/2014
Activating device commands via the "Device commands" dialog box
All device commands of the regenerative power supply module are available in the
»Engineer« in the Device Commands dialog box:
 The Device Commands dialog box can be opened by clicking on the setting of C00002
on the All Parameters tab.
 During and after the execution of the device command, the processing status is
displayed in the Device Commands dialog box:

Note!
If you click on a device command in the list field of the Device Commands dialog
box, the corresponding device command is executed immediately!