Lenze E94ARNE Regenerative power supply - Manual (Page 49)

EDS94ARNExxxx EN 2.3 - 06/2014
L
49
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.10 Stop application
The C00002 = "32: Stop application" device command serves to stop the application
started in the regenerative power supply module.
[4-7] "Stop application" function
 Only possible when controller is inhibited.

Tip!
The icon in the Toolbar inhibits the regenerative power supply module and
stops the application in the regenerative power supply module at the same time.
Possible status displays for this device command
Related device commands
 Start application
( 48)
 Inhibit controller
( 55)
Memory module MM
9400
RAM
Firmware Application 1 Application
Application 2
Application 3
Status ( C00003 ) Meaning
2131202 Device command in process
2097152 Device command executed successfully
2097153 General fault