Lenze E94ARNE Regenerative power supply - Manual (Page 264)

9400 regenerative power supply module | Parameter setting
Internal interfaces
LS_SyncInput - status information for the sync telegram
264
L
EDS94ARNExxxx EN 2.3 - 06/2014
9.7 LS_SyncInput - status information for the sync telegram
The LS_SyncInput system block provides status information concerning the sync telegram
received via the system bus in the function block editor.
Outputs
 Synchronisation of PDOs via sync telegram ( 115)
Identifier
Data type
Value/meaning
SYNC_wSyncCycleTime
WORD
Sync cycle time in [μs]
• The sync cycle time, which can be set in C01121 , is the time interval with which
the internal phase-locking loop (PLL) expects the sync signals. It must be set
appropriately with regard to the cycle of the synchronisation source selected in
C01120 .
SYNC_wSource
WORD
Synchronisation source selected in C01120 :
0 OFF
1 CAN on-board
2 CAN module
4 Module in MXI1
5 Module in MXI2
6 Digital input 1
7 Digital input 2
8 Digital input 3
9 Digital input 4
10 Digital input 5
11 Digital input 6
12 Digital input 7
13 Digital input 8
SYNC_nSyncDeviation
INT
Deviation of the synchronisation signal in [increments]
• ±16000 increments ≡ ±1 ms
SYNC_bSyncInsideWindow
BOOL
Status signal "Synchronisation signal within time slot"
TRUE The last synchronisation signal was within the time slot
parameterised around the expected value via C01123 .
SYNC_bSyncSignalReceived
BOOL
Status signal "Synchronisation signal received"
TRUE Synchronisation signal has been received.
SYNC_nSyncDeviation
SYNC_wSyncCycleTime
SYNC_wSource
SYNC_bSyncInsideWindow
SYNC_bSyncSignalReceived
LS_SyncInput
SYNC SYNC