Lenze E94ARNE Regenerative power supply - Manual (Page 317)

EDS94ARNExxxx EN 2.3 - 06/2014
L
317
9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C00591
C00591
C00594
C00595
Parameter | Name:
C00591 | Resp. to CAN-RPDOx error
Data type: UNSIGNED_8
Index: 23984
d
= 5DB0
h
Response if the corresponding CAN RPDO has not been received within the configured time or with the configured
sync.
 "CAN on board" system bus
Selection list (Lenze setting printed in bold)
1 Fault
2 Trouble
4 Warning locked
5 Warning
6 Information
0 No response
Subcodes Lenze setting Information
C00591/1 0: No response Response to non-received RPDO1 ... RPDO4
C00591/...
C00591/4
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00594 | Resp. to failure t. sensor filter
Data type: UNSIGNED_32
Index: 23981
d
= 5DAD
h
Response to filter temperature sensor error.
• The response to a too high filter temperature via PTC input T1/T2 can be selected in C00585 .
Selection list (Lenze setting printed in bold)
1 Fault
5 Warning
0 No response
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00595 | Resp. to CAN bus OFF
Data type: UNSIGNED_8
Index: 23980
d
= 5DAC
h
Response if CAN node switches to the bus off state.
 "CAN on board" system bus
Selection list (Lenze setting printed in bold)
1 Fault
2 Trouble
4 Warning locked
5 Warning
6 Information
0 No response
 Read access  Write access  CINH  PLC STOP  No transfer