Lenze E94ARNE Regenerative power supply - Manual (Page 77)

EDS94ARNExxxx EN 2.3 - 06/2014
L
77
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.35 Prepare firmware update
 Only possible when the controller is inhibited and the application has been stopped.
Possible status displays for this device command

Note!
For Lenze service only!
The
C00002 = "10000: Prepare firmware update" device command serves to set
the regenerative power supply module to the firmware update mode to carry
out a possibly required update of the firmware using the corresponding
software.
Status ( C00003 ) Meaning
655394050 Device command in process
655360000 Device command executed successfully
655360001 General fault