Lenze E94ARNE Regenerative power supply - Manual (Page 50)

9400 regenerative power supply module | Parameter setting
Device interface
Device commands
50
L
EDS94ARNExxxx EN 2.3 - 06/2014
4.1.11 Reset program
The C00002 = "33: Reset program" device command serves to reset the application
program in the regenerative power supply module.
 All variables are reset to their initialisation values.
 The situation corresponds to the start of a new program loaded into the control system
(cold start).
Possible status displays for this device command
Related device commands
 Delete program ( 51)
 Restart program
( 52)
Status ( C00003 ) Meaning
2196738 Device command in process
2162688 Device command executed successfully
2162689 General fault