Lenze E94ARNE Regenerative power supply - Manual (Page 63)

EDS94ARNExxxx EN 2.3 - 06/2014
L
63
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.23 CAN on-board: Reset node
The C00002 = "91: CAN on-board: Reset node" device command serves to reinitialise the
CANopen system bus interface of the regenerative power supply module ("CAN on board"),
which for instance is required, for instance, after changing the data transfer rate, the node
address, or identifiers.

Tip!
For detailed information about the "CAN on board" CANopen system bus interface,
please see the "CAN" Communication Manual.
Possible status displays for this device command
Related device commands
 CAN on-board: Pred.Connect.Set
( 65)
 CAN on-board: Identify node
( 67)
Status ( C00003 ) Meaning
5997826 Device command in process
5963776 Device command executed successfully
5963777 General fault
6003200 CAN fault
... ...
6003455 CAN fault