Blackmagic Design DaVinci Resolve Advanced Panel - Manual (Page 260)

COLOR 260
Methods of selecting and adjusting individual control points using the master trackball of the
center panel:
To select a control point to adjust:
Spin the fourth ring control to the left or right to select the next
control point in that direction. It takes about half of a turn to select
another control point.
To move a selected control point:
Adjust the fourth trackball to move the control point up, down,
left, or right. Selected control points are constrained between
whichever control points are to the left and right.
Another set of rotary knobs let you adjust Curve Mix and YSFX parameters.
To adjust the Curve Mix sliders:
• Adjust the LUM CURVE, RED CURVE, GREEN CURVE, or BLUE CURVE
rotary knobs.
To make YSFX adjustments:
• Adjust the LUM YSFX, RED YSFX, GREEN YSFX, or BLUE YSFX rotary knobs.
About the Soft Clip Tab
The Soft Clip tab provides an interface for adjusting highlight and shadow soft-clipping on a per-clip
basis. This is in contrast to the Generate Soft Clip LUT settings of the LUTS tab within the Config page,
which let you set one simplified soft-clipping setting for the entire program.
The curve Clipping controls