Blackmagic Design DaVinci Resolve Advanced Panel - Manual (Page 77)

CHAPTER CONFIGURATION
CONFIGURATION 77
6
In each case the target clips are set to:
Exact values changed: Changes made to the current scene are rippled to the
additional scene(s) using the exact control setting changes.
For example, if Master Gain in the current scene is changed
and set to 75 percent of its range, each scene rippled will
then have a Master Gain setting of 75 percent. This is useful
for setting consistent levels throughout the entire list.
Percent value changed: Any change made to the current scene is rippled to the
additional scene(s) by the same percentage of change. For
example, if the current scene has a Master Gain level of a
hundred units and is changed to ninety units, then each
rippled scene will have a relative reduction of 10 percent
in its Master Gain level. This modification is based on the
Master Gain level in the rippled scene(s) before the change.
So if a particular rippled scene originally had a Master
Gain level of fifty units, the relative change of 10 percent
would reduce the rippled scene’s video gain level to forty-
five units.
Unit value changed: Any changes made to the current scene are rippled to the
additional scene(s) by the same number of units of change.
For example, if the current scene has a Master Gain level of
eighty units and is increased to ninety units, each rippled
scene’s master gain level increases by ten units.
All values are copied: The current scene grade is rippled, or copied, to other
events. No comparison is made with the original scene
memory, and all memory parameters are rippled.
Working Folders
These controls are used to change the file path for Proxy, Cache and Gallery storage data.
It is important that these settings are not set to the computer’s system disk as it will quickly fill up with
proxies/cache. If this happens it’s likely your computer will not boot the next time you start.
Resolve Working Folders