Blackmagic Design DaVinci Resolve Advanced Panel - Manual (Page 345)

CHAPTER DECK
DECK 345
13
Record
The Record tab provides controls to record images from the media storage disks to a video tape deck.
If you have a PowerMaster project it also offers control over the clips to be recorded from the timeline.
Select the appropriate clip from disk browser in the ‘Source Selection’ tab. Then acquire the deck by
clicking on the ‘Connect’ button and position the tape to the location where you want to record the
images, clicking on the ‘Mark In’ button within the Timecode on Tape section. Or, simply choose the
appropriate section where to record the material on the tape by typing in a timecode.
Check the Assemble/Insert/Crash setting under the Viewer to make sure it’s as you require. Note: When
DaVinci Resolve is performing a Batch Output operation you can only select between recording the
clips with an Assemble edit or a Crash record. Click on the ‘Record’ button to start the process of
exporting the material to the tape. Once finished, you can check the recording using the transport
controls or click on the ‘Connect’ button once again to release control of the machine. You will need to
disconnect prior to exiting the Deck screen.
Clip Information
Within the Clip Information display you will see the timecode for the start and end of the clip, as defined
by the clip’s metadata. Trim the start and end points; the + and – buttons will either add or subtract
frames from the values displayed.
Deck Page Record Tab