Blackmagic Design DaVinci Resolve Advanced Panel - Manual (Page 67)

CHAPTER CONFIGURATION
CONFIGURATION 67
6
The filter selection for monitor scaling is usually set to basic and only enabled to smooth edges when
viewing with a video projector and a very large screen. These settings minimize any high frequency
artifacts that may be seen. This may also be noticeable if you have a 2K or HD project but are monitoring
on a SD monitor. Normally this should be in the basic mode. The other options, Bilinear, Bicubic and
Bspline will have different impact depending on your display device so you may need to test each to
verify which is best for your facility.
The 3:2 Pull down switch can be utilized for monitoring in NTSC while the user grades 24fps material.
If you have selected NTSC, 59.94i or a playback rate of 24fps will automatically activate this option.