Rockwell Automation 2094-EN02D-M01-Sx Kinetix 6200 and Kinetix 6500 Modular Multi-axis Servo Drives User Manual - Manual (Page 229)

Rockwell Automation Publication 2094-UM002E-EN-P - May 2012 229
Removing and Replacing the Kinetix 6200 and Kinetix 6500 Drive Modules Chapter 9
Replace the Power Rail This procedure assumes you do not need to change the location of the power rail
on the panel and you intend to reuse the mounting bolts of the power rail you just
removed.
Follow these steps to replace the power rail.
1. Align the replacement power rail over the existing mounting bolts.
2. Tighten the mounting bolts.
3. Reattach the braided grounding strap to the power rail grounding stud
(refer to page 228 ).
IMPORTANT If you need to change the location of the power rail, or if you are installing a
power rail designed for additional or fewer modules than you removed, refer to
Kinetix 6000 Power Rail Installation Instructions, publication
2094-IN003 .
ATTENTION: To avoid damage to the power rail during installation, do not
remove the protective covers until the module for each slot is ready for
mounting.
IMPORTANT To improve the bond between the power rail and subpanel, construct
your subpanel out of zinc plated (paint-free) steel.