Appendix e - rbm module interconnect diagrams, Before you begin, Appendix e – Rockwell Automation 2094-EN02D-M01-Sx Kinetix 6200 and Kinetix 6500 Modular Multi-axis Servo Drives User Manual User Manual
Page 277: Rbm module interconnect diagrams, In appendix e, Appendix
Rockwell Automation Publication 2094-UM002E-EN-P - May 2012
277
Appendix
E
RBM Module Interconnect Diagrams
This appendix provides Bulletin 2090 Resistive Brake Module (RBM)
interconnect diagrams specific to Kinetix 6200 and Kinetix 6500 modular
servo-drive systems.
Before You Begin
These procedures assume you have installed your RBM module with the
Kinetix 6200 or Kinetix 6500 servo-drive system. For RBM module installation
instructions, refer to the Resistive Brake Module Installation Instructions,
publicatio
For Kinetix 6200 drive systems, you can set the delay time for your RBM module
in RSLogix 5000 software. Refer to Configure Axis Properties on
.
For Kinetix 6500 drive systems, you can set the delay time for your RBM module
in RSLogix 5000 software. Refer to Configure Axis Properties on
.
Topic
Page
ATTENTION: The interconnection diagrams should be used as a general
recommendation on how the safety control circuit may be implemented. Actual
applications may vary due to requirements based on the machine builders risk
assessment. The machine builder must perform a risk assessment and
determine a category level of safety that must be applied to the machine.