Delta RMC151 - Manual (Page 1102)

RMC70/150 and RMCTools User Manual
only)
2 Rearm (Write
Only)
3 Read Active
(Read Only)
4 Trigger Enabled
(Read Only)
F38:1 19459 D19458 REAL %MD38.1 UDINT Read/Write Plot Samples (e.g.
1000)
F38:2 19461 D19460 REAL %MD38.2 REAL Read/Write Plot Sample Period
(seconds)
F38:3 19463 D19462 REAL %MD38.3 DINT Read/Write Plot Axis Owner
0-3, -1 = none
F38:4 19465 D19464 REAL %MD38.4 REAL Read/Write Plot Trigger Position
%, 0-100, -1 =
auto rearm
F38:5 19467 D19466 REAL %MD38.5 UDINT Read/Write Plot Trigger Type
0-
7
Trigger Type
(0=none,
1=motion
command)
8-
23
Depends on
trigger type
Motion
Commands:
8-
11
Axis 0-3 bits,
if all zero,
then use
Axis Owner
12-
23
Reserved
F38:6 19469 D19468 REAL %MD38.6 - - Reserved
F38:7 19471 D19470 REAL %MD38.7 - - Reserved
F38:8 19473 D19472 REAL %MD38.8 REAL Read Only Plot ID
F38:9 19475 D19474 REAL %MD38.9 REAL Read Only Plot State
0 = not triggered, 1
= capturing, 2 =
complete
F38:10 19477 D19476 REAL %MD38.10 DINT Read Only Plot Captured
Samples
Number of plot
samples captured.
Only applies for Plot
State > 0.
F38:11 19479 D19478 REAL %MD38.11 DINT Read Only Plot Sample 0 Time
Time that first plot
sample was
captured. In control
1082 Delta Computer Systems, Inc.