Delta RMC151 User Manual

Page 552

Advertising
background image

RMC70/150 and RMCTools User Manual

The RMC150 does not support serial RS-232 or RS-485. However, the RMC150E can

communicate to serial RS-232/485 devices via serial-to-Ethernet converters, available from

manufacturers such as Lantronix (UDS100-IAP) or Allen-Bradley (1761-NET-ENI). Contact

Delta for more information.
The RMC75S has two communication ports, which can be used simultaneously:

Monitor Port (Port 0)

The RMC75S Monitor Port (port 0) is intended to be used for communication with

RMCTools, but may also be used with other devices. This port supports only RS-232 at

fixed settings. For details, see the Monitor Port topic.

Notice that the RMC75P also has a serial RS-232 serial Monitor port.

Port 1

Port 1 on the RMC75S module is intended to be used for communication with devices

such as PLCs and HMIs. Port 1 supports either RS-232 and RS-485 (2-wire only). See

the Configuring Serial Communications topic for instructions on how to configure port

1.


For basics on using serial communications, such as reading and writing registers and issuing

commands, see the Using Serial Communications topic.

Features

The RMC75S serial port 1 has a great amount of flexibility, as summarized below:

Protocols:

o

Allen-Bradley DF1 (Full- and Half-duplex)

o

Modbus/RTU

o

Mitsubishi Bidirectional Protocol

Baud Rate: 9,600 to 115,200

Parity: Odd, Even, or None

Line Drivers: RS-232 and RS-485

Termination and Biasing (RS-485 only): Both jumper-selectable on the connector

Setup

Because of the large number of options offered by the RMC70, setting it up can be

intimidating to users new to serial communications. Read each of the following topics

carefully before designing your serial network:

Configuring the RMC7xS Serial Communications
Line Drivers: RS-232/485
Serial Network Topologies
RS-232 Wiring for the RMC70
RS-485 Wiring for the RMC70
RS-485 Termination and Biasing

Protocols

The following topics describe how to use each protocol supported by the RMC75S:

DF1 (Full- and Half-Duplex)
Modbus/RTU
Mitsubishi Bidirectional Protocol

Using Serial Communications

See the Using Serial Communications topic.

532

Delta Computer Systems, Inc.

Advertising
This manual is related to the following products: