Delta RMC151 User Manual
Page 599
6 Communication
This window shows all settings that can be configured in the RMC. Notice that only
the 0005 Produced Data Length and 0006 Consumed Data Length
parameters are used with the Omron controllers. The producer and consumer
locations were set within RMCTools earlier in this process, and the RPI will be set
later in the process.
b.
For the 0005 Produced Data Length parameter, enter the number of registers
that you want the RMC to send cyclically to the PLC. If you chose to use the Sync
Register, then this value must include the Sync Register.
c.
For the 0006 Consumed Data Length parameter, enter the number of registers
that you want the PLC to send cyclically to the RMC. If you chose to use the Sync
Register, then this value must include the Sync Register.
d.
Click OK.
8.
Create Tag Sets for the Input and Output Data
Before establishing an I/O connection, the location for the I/O data in the Omron PLC
must be configured. The following procedure describes one way of doing this.
However, be aware that the tags must be known about both by CX-Programmer and
Network Configurator. Section 6-2-4 Creating Tags and Tag Sets of the Omron
EtherNet/IP Units Operational Manual (W465) manual describes other methods
of creating tag sets.
deltamotion.com
579